Round Stainless Steel Tail light assembly

 

 

Well, here we are with my Stainless Steel rear tail light assembly, this is a great set up for many many motorcycles etc.

I have used this on quite a few of my own machines over the years and now it is available to you lot again and this also has a great looking GLASS Red lens.

 

Just have a look at the light and you make your mind up if you want this or not, but I love the look of it, it functions very well and indeed.

 

Plus, being stainless it will not rust and it will shine on in any weather, the glass liens is a nice touch and gives it that Old Time flavor that many of us are searching for on our creations.

 

 

This is dead easy to fit and will really tidy up the rear end of your motorbike and get plenty of people asking about it that’s for sure.

 

This is a two wire system, so you simply run the Black wire to your Brown on your harness, you then run the Red to the Green with the Yellow stripe, then, if the stop light wont function, I always run a ground (Green) from the nut on the back of the light and into the Solid Green on the harness and that’s it real easy and boy does it look clean.

 

 

This weighs in at almost half a pound and not a light weight rear tail light but it looks a million bucks and I hope you like it as much as I do?

 

 

 

This lamp is 3 7/8 total in Diameter

 

 

You will need to drill a 1 1/2 inch hole in the center of where you will fit this to allow the Bulb holder to make the light sit flush, then simply drill TWO 13/16ths holes to allow for the 1/4 inch studs to go through, fit the nuts and you are done.

I will continue to fit these to many other machines.

 

Comments

comments